Steps to Limit Network Traffic with Cisco Routers

Cisco router support number

Specialized in networking devices along with other electronic equipment’s, Cisco is probably the best brand for routers in America, especially in terms of the connectivity that it offers. Known for their innovative and advanced products, Cisco Routers are commonly used in both large and small scale organizations. However, in spite of so many benefit that it offer, the assurance of limiting network traffic is still questionable with Cisco. So, if you are also worried about the same, you can take help from Cisco customer support or you can simply follow the below mentioned steps.

  • In order to start with the process, you should enable Cisco Express Forwarding first. Make sure that you go to the global configurations mode and as soon as you visit there, you will be prompted with command codes. Don’t ever forget to key “Router# config t” first, followed by pressing the enter button. While you are moving ahead, key in “Router (config) # ip cef,” also you need to press enter again and key in “Router (config) #”.

  • As you move to the next step, you are supposed to formulate an Access Control List. Formulating access control list will help you in the allowance for accessing the traffic you primarily want to limit. All you need to do is to go to the resources page while finding configuration commands for limiting the traffic. Also, one can use the command (Config-acl) when you use the global configurations.

  • In the next step, you are supposed to modify the committed access rate, followed by allocating the bandwidth amount to the source of the traffic. Here is the proper syntax for that “rate-limit {input | output} [access-group [rate-limit] acl-index] bps burst-normal burst-max conform-action action exceed-action action”. All you need to do is to key this in the interface.

  • In the other hand, one must also need to familiarize oneself with Cisco-language along with referring to the manual in order to find the meaning of the word, “access group”, input and output and the rate limit.

  • In the last step, users are supposed to refer to the global configurations page every time you want to monitor traffic. It is also advisable to bring change in the syntax and the parameters to those you want to limit network traffic.

However, if you find the above given steps too complex, it’s better for you to give a call on Cisco router support number in order to seek special assistance from the experts. Also, if you don’t have their customer service number, make sure that you avail it from Contactforhelp, which is an online directory.

Leave a Reply

Your email address will not be published.

play Quiz *